Sieving Machine Calibration Using a Profile Projector with Standard Method ASTM E-11 2004

  • Muftil Badri Department of Mechanical Engineering, Universitas Riau, Indonesia
  • Dodi Sofyan Arief Department of Mechanical Engineering, Universitas Riau, Indonesia
  • Aji Mahmud Solih Balai Besar Bahan dan Barang Teknik Bandung, Indonesia
  • Dyna Ayunita Department of Mechanical Engineering, Universitas Riau, Indonesia
  • Afdila Muflihana Department of Mechanical Engineering, Universitas Riau, Indonesia

Abstract

Sieving machine is used to sift material of sand and stone previously mixed. Sieve machine is a measuring instrument to determine the size of sand grains that can be used in building construction. The purpose of this research is to calibrate the sieving machine using profile projector with standard method ASTM E-11 2004. Based on this research, the conclusion of calibration data of sieving machine has been obtained. It was found that the sieving machine used in this research can be used to determine the size of sand grains used for construction. The uncertain value of the width opening sieve is 15.8 μm and the diameter of wire is 0.02 mm, so that the value of evaluation is lower than the allowed geometry deviation limit. Thus it can be concluded that the sieve machine is still within the permissible geometry tolerance limit

##Keywords:## Sieving Machine, Calibration, Profile Projector
Published
Oct 7, 2018
How to Cite
BADRI, Muftil et al. Sieving Machine Calibration Using a Profile Projector with Standard Method ASTM E-11 2004. Journal of Ocean, Mechanical and Aerospace -science and engineering-, [S.l.], v. 57, n. 1, p. 1-4, oct. 2018. ISSN 2527-6085. Available at: <https://isomase.org/Journals/index.php/jomase/article/view/25>. Date accessed: 19 aug. 2024.
Citation Formats
Issue
Vol 57 No 1 (2018): Journal of Ocean, Mechanical and Aerospace -science and engineering- (JOMAse)
Section
Articles